Super Endo Inlay Preparation Burs Kit

SuperEndo Inlay Preparation burs are designed to offer speedy, simple, and accurate tooth preparation for a wide range of crown and bridge restorations, veneers, and Onlays.

Precise depth orientation grooves can be achieved easily with the specially designed depth cutting diamond points.

Features :-

• Durable Burs with multi-layer coating.
• Silicon inside hold burs tightly
• Full set autoclavable.
• Evenly distributed diamond particles
• Sturdy built

Advantage :-

• Long service life and high cutting capacity when preparing and separating porcelain, facing composites and model materials.
• Precise dimension and stable control of quality.
• Enjoy low price but high quality.

• Shank type – Friction grip
• Construction – Stainless steel Shank Coated with diamond particles
• Autoclavable upto 134°C 

Color band on shank:

• Regular – Blue
• Fine – Red
• Superfine – Yellow

Set Of 10 Piece 

• SI-48
• DI-42
• FO-22EF
• EX-21EF
• SF-21
• TF21F
• TF-31
• TF-22
• SF-21F
• EX-18F

1 X 10 Burs in SuperEndo Inlay Preparation Burs Kit

• Insert the instrument as deeply as possible into the chuck (Friction Grip).
• Set the handpiece at the required working speed before applying the instrument to the treated area.
• Apply a maximum operating force of 0.4 [N] and do not exceed a speed of 230’000 [rpm].
• Activate water spray during the entire treatment (minimum 50 mL/min).
• Regulate water flow in case of water excess or shortage.
• It is recommended to use a dental dam.
• Use the instruments over the entire length of their working part and not just at the tip, so as to avoid an unconscious increase of the contact pressure causing local overheating.
• Once the preparation has been completed, remove the instrument from the site and allow it to come to a standstill.
• It is recommended to wear gloves and safety glasses.
• After use, remove the bur to clean and sterilize according to protocol
• Do not use the bur if its bent or if the surface diamond coating has worn- off

Q. Can these burs be autoclaved ?

A. Yes, these burs indeed come in a packaging that can be autoclaved and the burs can be reused thereafter.

Q. What should I do to prevent instrument fracture ?

A. Avoid jamming or levering actions when rotating, as this increases the risk of instrument breakage. Never exceed the specified maximum speed. Avoid applying forces greater than the recommended values, as this could cause damage to the instrument and the treated area. Always Check for possible damages; dispose of oxydized, blunt and eccentric instruments.

Q. When to dispose these Inlay Preparation Burs ?

A. Check for possible damages; dispose of oxydized, blunt and eccentric instruments