GC G-Cem Linkace-Translucent

• Excess cement is easily removed in one piece after only a 1-2 second tack cure.
• high flexural and bond strengths prevent loss of retention even when a classical preparation is not possible.
• HEMA-free and shows very low water uptake, delivering exceptional colour stability.

ADVANTAGES

The working time is 3 minutes 30 seconds from start of mix at 23°C (73.4°F).

Setting time: 4 minutes after removing excess material

Halogen/LED, intensity for ceramic, indirect composites and metal-based restorations: 700mW/cm2, covering wavelength: 430 to 480 nm)

(Halogen/LED, intensity for fiber post, metal ceramic, cast post and core: 700mW/cm2, covering wavelength: 430 to 480 nm). b) Let the material set for another 4 minutes.

In case of a cast post and core, let the material set for 10 minutes.

CONTRAINDICATIONS

1. Pulp capping.

2. In rare cases the product may cause sensitivity in some people. If any such reactions are experienced, discontinue the use of the product and refer to a physician.

3. This product is not indicated for filling or core build-up.

STORAGE

Store at room temperature away from heat, moisture and direct sunlight (4-25°C) (39.2-77.0°F).

Shelf life: 2 years from date of manufacture

CAUTION

1. In case of contact with oral tissue or skin, remove immediately with a sponge or cotton soaked in alcohol. Flush with water. To avoid contact, a rubber dam and/or cocoa butter can be used to isolate the operation field from the skin or oral tissue.

2. In case of contact with eyes, flush immediately with water and seek medical attention.

3. Do not use G-CEM in combination with eugenol containing materials as eugenol may hinder G-CEM from setting or bonding properly.

4. Use a protective light shield or similar protective eye wear during light curing.

5. This product is not indicated for filling or core build-up.

• 2 x G-CEM LinkAce Syringes (4.6gm, 2.7ml each
• 15 x Automix Tip Regular
• 5 x Automix Tips for endo (with 5x Extension Tips)